Hi Gang.
I am running an adv v-carve with Carbide Create V7. On the final pass of the ‘V’, the cutter rapids to these locations, and makes these little tick marks in what should be a straight line vector. I can see little tick marks in the tool path (yellow high-lites), but there are no nodes there in the design file.
They are so small, it doesn’t impact the project. However, I’d like to understand what’s going on. Although it doesn’t impact the project, it is a runtime hit, and I’d like to avoid this mistake in any future designs if it is something I did with out knowing.
Regards,
Dave
