Who's using vacuum tables?

(Luke) #1

I’m thinking of buying one for smaller parts. Just curious what people are using and what types of pump are being used.

0 Likes

(rlicquey@gmail.com) #2

I use vacuum pods instead of a full table, which means I can use a smaller pump. I have a Gast pump that is sold as a vacuum bagging system for veneering. It works extremely well, but I’ve not used more than one pod at a time. I think three would be about the maximum this pump could support. I believe it’s a 0.6 CFM (very low)

2 Likes

(Juan Posada) #3

If you have a compressor you can also try a venturi vacuum generator.

0 Likes

(mikep) #4

They’re super noisy though…

2 Likes

(Luke) #5

I have a small vacuum pump already I’m trying to find a good way to mill lots of little parts

0 Likes

(rlicquey@gmail.com) #6

You might find veneersupplies.com a valuable resource. https://www.veneersupplies.com/products/Podz-Vacuum-Clamping-Jigs.html . There’s a lot of information there about building vacuum systems for hold downs, etc. Also joewoodworker.com . Using info from these sites, I made some small vacuum hold downs from HDPE and the vacuum sealing tape they sell as well as the rubber seals used on canning jars.

2 Likes

(mikep) #7

Just ran across this:

1 Like

(system) closed #8

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.

0 Likes