Wiring confirmation for XYZ Probe on Carbide Controller 2.4d board

Hi all,

I just want to confirm which wires are the 5v, Signal and Ground for the ‘BitZero’ end connector as shown in the following Carbide photo >

This is for the Controller 2.4d board which i have. The tutorial itself is at https://docs.carbide3d.com/assembly/touch-probe/#version-24de

I have an OpenBuilds XYZ probe that i plan to connect - so need to know which wire is which. I then need to figure out how to get a macro created in CNCJS to use this!



I believe those pins are, from top to bottom:

  • GND
  • 5V
  • Switch

You can also use the probe header: left pin is switch, right pin is GND.

1 Like

Need something different that what’s found here?


This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.