This ZIP file contains tWO versions (7m and 7mW) of my Post-Processor for Vectric Vcarve,
Desktop or Aspire, version 11 and above CNC design software for use with the Carbide
Motion (CM) gcode sender version 635 and above, and also includes the associated
supporting User Guide.

Both versions 7 are for Spindle/VFD only.  Version 6 for Trim Routers and versions for
Vectric 9 can be found in earlier posts.


The versions history summary are as follows:
----------------------------------------------------------------------------------------------------------

SPINDLE VECTRIC V11+ versions:
v7d: a revised v6 supporting Spindle/VFD messages on CM Status line.

v7e: an updated v7d adding a 1-minute initial Spindle/VFD warmup routine.

v7f: an updated v7e adding a 1-second Dwell when raising Z to SafeZ to prevent rapid
XY moves into keep-out zones.

v7g: an updated v7f adding my POSTP version info to the gcode file end archive info section.

v7h: updated zero origin move, added more info to archive section, deleted 1-min embedded warmup.

v7hW: same as v7h but retained embedded 1-minute warmup routine.

v7i: skipped

v7j: not released

v7k: fixed laser rapid support and added origin datum prompt. Also fixed an issue with dust boot
 messaging between older Shapeokos and 5Pro.

v7kW: same as v7hw but fixed laser rapid support and added origin datum prompt.  Also fixed an
issue with dust boot messaging between older Shapeokos and 5Pro.

v7l: skipped

v7m: Replaced command M1 with M0, added an additional dwell pause for 5Pro machines to fix
dust boot pauses.

v7mW: same as v7m but retains the 1-minute spindle warm-up routine.

=====================================================================
*******************************************************************************************************
*******************************************************************************************************
the end.