Carbide Motion V.4/Grbl 1.1 Door Open Error

[ssnargpilot (Louie Jones)]

I updated to Motion 4 and flashed the board to 1.1f to use the new Probe, and when I try to Jog the machine I keep getting a “Door Open”, seems kinda strange when the machine is a Shapeoko XL. Jorge was kind enough to replace the controller board, but still have the same problem.Any ideas? Any help would be greatly appreciated

[WillAdams (William Adams (Carbide 3D))]

Please see if

Shapeoko Touch Probe causes Door Open Error

Hi mark, could you humor me and connect the probe to the pins next to the Z limit switch? There’s no estop on 2.4 boards regardless of letter version, and I think you might have hooked up to the feedhold. If that’s not it we’ll gladly swap boards like Will said.

addresses this — if not, let us know at support@carbide3d.com and we’ll try to help sort it out.