Fusion 360 CAM Modeling and Simulation

(Ben Veghte) #1

I am working on a project using Fusion 360 and was making one of the tool paths and I wanted to watch it with the simulation thing and it didn’t look like the tool would reach all of the way to the edge of my design specs, so I ran it And I as right. The hole that it was supposed to cut out was too small. I know that I have my dimensions right because I have checked multiple times.

Any ideas?

(thebsuguy) #2

Its really hard for me to help without images and measurements. Even better if you post ur 360 file ill be happy to look at it.