Hi all, is it normal for the Nomad to have power blips when there is too much instantaneous torque on the spindle? This often happens to me if I am slotting too fast, but occasionally it will even restart when the spindle powers up.
I don’t have a Nomad, but I’ll say no…it is not normal.
Maybe a power supply issue?
I’d contact Carbide3D support.
1 Like
Ditto. Not normal. Make sure the Power supply connector to the Nomad is OK (pull it out, do a visual check, make sure it seats back in nicely) would be my only suggestion before contacting C3D support.
2 Likes
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.