@MadHatter I truly appreciate the details and the recommendation. I ended up picking up 10 drill bits and 5 endmills, and then ordered another 20 endmills since stock levels from the seller were a bit low and I wanted to make sure I had enough on hand given the amount of use they are getting.
They’ve been working perfectly on hardwood and resin, allowing for both the small, deep pockets and pockets that clear the material, allowing for a really nice matte finish with minimal sanding (speaking to resin)
I landed on the following:
- Feed Rate: 600 mm/min
- Stepover: 20%
- RPM: 18,000
- Depth of Cut: 0.250 mm