#102-z Speeds and Feeds for rough cut in 6082T6 Aluminium

Hi, struggling to find an optimum toolpath set up in Meshcam for #102-z Cutter for rough cut in 6082T6 Aluminium. If anyone has an optimum setup I’d be grateful for a screenshot of your toolpath setings. Thanks in advance.

Oblig @wmoy video. Suggest starting here. Been a while since I fired up MeshCam but if I get a chance I’ll see how these can be applied in there.


This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.