This seems to be a common issue on 3D carving, where fuzzies are only on the left side. Here are some images of the issue. Maybe apply a coat of sanding sealer after the finishing pass let it dry and run a second finishing pass? Or change the direction to 45°? The wood is Holly, but I get the same e…

3D Carve, Fuzzies only on the left side

WillAdams (William Adams (Carbide 3D)) August 28, 2026, 4:17pm 7

I suspect that one possible solution would be a pencil/waterline finishing pass such as MeshCAM has:

no idea if that is on the table to add to Carbide Create, or if folks would just be told to buy MeshCAM.

1 Like