5 pro issue with Bitzero V2

[WillAdams (William Adams (Carbide 3D))]

I wrote up a bit on this at:

Using/verifying the BitZero

Here is how I check out the functionality of the machine/BitZero: first check that you have sent the correct Z-axis configuration This can be easily done by jogging down to the wasteboard surface, setting zero, then using the Rapid Position command to lift 6mm above the current zero — measure how much the machine moved — if it’s wrong: open the Log Window go to the MDI (EDIT: Note that it will need to be enabled in options in current versions) and send $$ and check that the Z-axis steps/mm …

that said, it’s pretty much a binary thing, and if it doesn’t work, then something about the electronics or wiring may be wrong — write in to support@carbide3d.com and we’ll work out how to handle this.