Good morning, I am trying to figure out why my machine is trying to machine approximately 2 or 3 mm off the surface of the wood. I’m trying to figure out if I’m missing a step somewhere. Note: I am using a BitSetter. And I’m using CM 537. I clicked on [jog/position], and using the X, Y, Z axis’s,…

Thanks. Nothing suspicious there. The next step should really be to try this again with BitSetter disabled and double checking where your Z zero is at, right before starting the job, like Rob mentioned earlier

A bit of help with Carbide Motion

Software Carbide Motion

WillAdams (William Adams (Carbide 3D)) October 15, 2021, 2:13pm 3

Another possibility is not positioning the BitZero to match how you are probing — I wrote up a bit on that at:

which may help.