Anyone willing to share their settings for fusion for adaptive on the Nomad 3?
I haven’t done much aluminium yet, but when I did I took the settings from the old video:
And times things by 2.4 for feed rate/rpm. Plunge and ramp I kept the same. DOC I think I increased a bit (maybe .8mm for DOC)? You could probably go a bit more on the DOC, but I wanted the part to just ‘work’ so I was content.
Hopefully someone has more tested feeds/speeds. Again I just ran one part on aluminum so far.
2 Likes
This topic was automatically closed after 10 days. New replies are no longer allowed.