Available drawing for 5.1 4X4 with leg kit

[keithhoward55 (Keith Howard)]

Is there a drawing available for the Shapeoko 5.1 Pro with the leg kit installed? I would like a drawing like what is shown for the machine shown in the specification page from the website.

On a side note does anyone know what software they used to create the drawings for the machine? I was wondering if it was Autodesk Inventor, Fusion 360, Solidworks or even PTC Windchill?

Keith

[Bee (Brandon Lee)]

Hi,

I know of no such drawing, or what the original files are drawn in. That said here are a few threads here, the first even says add holes where you need them.

Shapeoko 5.1 Pro 2x2 Leg Kit Aluminum Extrusion Enclosure

Hi! I have owned my 4x2 Shapeoko 5 Pro for 3.5 years or so now and love the machine, but I need a bit more floor space in the garage workshop and I rarely use the full working area so I purchased a new 2x2 5.1 Pro a few weeks ago. I have seen a few discussions around building an enclosure with the leg kit, but haven’t seen too many folks go down this route. I’d like to show “V1” (aka the minimum viable product version) of my enclosure for the 2x2 to give you some ideas of what’s possible with…

and

5.1 Upgrade + Leg Kit

At last got the machine reassembled with the upgrade and table. Found out the space between the legs at their narrowest was 44.5" inches. My old table top was 44" just enough to rotate the machine 90 degrees and attach legs then slide out from under. All I can say after the initial test run is - WOW! I had thought the machine ought to be quieter with a more rigid setup. Coming from Kreg table with my best attempt to reinforce a thick MDF tabletop with 2x4’s - but on casters - its like night…