Bit setter case question

[LiamN (Liam Newcombe)]

Is that the one from this thread?

Zeroing on Shapeoko

I have a touch probe and a bit setter. But I purchased a Bit Probe Setter Case off of Etsy. It holds the touch probe and has a bit setter built into it. Looks like a good idea. BUT… I can’t imagine how this, attached by an overhang to the front brace of the Shapeoko, will set my X and Y axis. Or the Z for that matter. It seems to me I would need to set the axis zeroes using the touch probe in the usual lower left corner position. I’m new to this ( you already figured that out) and feel a little…