BitSetter (Rectangular) Connections Question

[vkazdoba (Victor Kazdoba)]

I just purchased the Shapeoko 4 (Standard) and am assembling. My next step is to install/connect the bitsetter. I review the install instructions for both the 4 and the bitsetter, but still dont get it.

I connected the cable in the controller and don’t know where to connect the cable on the bitsetter. The bitsetter itself does not contain any connection points, only the button and an empty cavity.

Any assistance is greatly appreciated.

Thanks

[Julien]

@vkazdoba

only the button and an empty cavity.

This does not sound right, contact support@carbide3d.com to let them know and they should be able to sort it out

[vkazdoba (Victor Kazdoba)]

I just contacted carbide 3d support and they confirmed that the sensor board was not installed in the bitsetter. They are working to rectify now.

Thanks for your reply.