I’m sure I’m not the first to have done this… I start a new program, turn on the spindle and click “Ok”, which makes the cutter go to the Bitsetter and results in this: [IMG_0293] I manged to make an emergency stop, but it still cut a bit in the Bitsetter. Does it have any consequences or can I s…

Bitsetter screwup

CrookedWoodTex (Tex (Don't Mess With My Texas!)) January 27, 2021, 12:58pm 4

Explained in that post, but the BitSetter works on relative measurements. (I just happened to have that magnetic opportunity! )

Even C3D followed that lead.

2 Likes