Boolean operations in Carbide Create

[WillAdams (William Adams (Carbide 3D))]

Until that’s released, I documented a pretty straight-forward technique for doing this at:

Let's make a coaster

The prototypical first job for a Shapeoko is to cut a coaster — here we do this using Carbide Create, trying to make the job as simple as possible, but adding a bit of interest with an inlay, and increasing the utility of the object by rounding off the corners. Before any real setup it will be best to go into Job Setup and Clear the drawing, and set the measurement units — please use mm (metric) for this tutorial. Note that the feeds and speeds in the Carbide 3D charts are given in Imperial inc…