Bowl bits vs cove bits?

[WillAdams (William Adams (Carbide 3D))]

Cove (radius) bits are the opposite, see:

Using unsupported tooling in Carbide Create: Roundover / Cove / Radius bits

These are usually used in routers for decorative effects in wood: but they are potentially useful for joinery: They are also useful for rounding off parts to allow rotary motion as for a hinged lid. Unfortunately, Carbide Create does not support this endmill geometry — but using the new support for previewing a V endmill when used in a No Offset Contour toolpath, it should be possible to preview them w/ confidence by stacking a series of V endmill cuts.

Usually bowl bits have a rounded edge and flat bottom, but not sure if that’s a strict criteria for inclusion.