Box joints on Shapeoko 3

Hi All,
I have the vertical table set up on my #3. Would like to try cutting small, 1/8" or smaller box joints.
Anyone done this ? JointCam software or other methods ?

Thanks in advance !

I wrote a bit about this at:

and expanded on it at:

That said, I think a partial blind technique which allows cutting things flat on the machine is preferable — single setup/fewer operations and w/ the technique shown at:

should allow one to cut one set of parts (say the sides), then to cut the other parts (the ends) and test the fit — if things don’t fit, then adjust the file and recut until things to fit.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.