"Busy" when using Keyboard to Jog in Carbide Motion

[CullenS (Cullen Simpson)]

Carbide Motion V6 Beta

I have not tried the windows version but when you do the PI build can you look into the key buffer? I am using the TechKeys board and it seems to overload CM when holding down any axis move key for a bit. Sometimes a short bit. The move will pause and CM shows busy. It would resume until you let up on the key and let it clear. I assumed it was a hardware issue but when I open a terminal window the keys just keep scrolling away as long as I have it pressed. The touch screen does not have the is…

That was the tread I mentioned the issue in earlier.

I wonder if the jog dial would have the same issue.