Carbide Motion (428) sending wrong config data for x/y size? (grbl params 130, 131)

[Luke (Luke (Carbide 3D))]

Please see this:

HDZ/Suckit Users - Addressing rapid coordinates X bouncing

Whilst we formally address support of the Suckit Dust Boots with HDZ users I wanted to post a workaround which will allow users to use the full 9 point rapid co-ordinates system in Carbide Motion with HDZ with a Suckit Dust Boot if they so please. Issue: At present if you are using CM 4.28 onwards, X travel is set to support the full HDZ travel distance (this is greater than the stock carriage due to the HDZ being narrower). If you are using a Suckit dust boot and additional ‘ears’ this removes…