Carbide Motion - Restart - Late warning of illegal entry line

[jtclose (Jim Close)]

I needed to use the Restart program option today.

I entered the line number, CM went along and got to the Point just before it lowers the Z axis for contact and a legitimate warning came up stating the entry point is associated with an Arc.

The path is a Fusion generated Parallel with smoothing ( lots of small arcs ) on a image relief generated mesh. I could not find a point near the entry point that was not associated to an arc.

I understand the warning, but being coupled with the lack of bait out

Carbide Motion - No bail out on restart at line

I used the restart program ( version 653 ) today and after the tool went to the correct starting point, I realized I wanted to bail out. I could not do that, I had to stop the CM application. What did I miss ?

I had to quit and rehome. Dang.

Please put the warning earlier or provide a bailout.