Carbide Motion ver 640 and bitsetter

Software Carbide Motion
1

Instead of telling you everything that I tried for over 2 hours, I’ll just ask how to do it.
I physically moved my bitsetter device and when I change a bit, it goes back to the old position. How do I permanently change the location of bitsetter in the Carbide Motion software?

2

Run Setup new machine

https://carbide3d.com/hub/docs/shapeoko-setup/

Make sure you hit save on that setup step, before next.

1 Like
3

Thank you very much. I of course did this initially but thought that you could just change the bitsetter setting VS make a new machine. Again thank you VERY much.