After installing bitsetter and CM 428, My xxl with HDZ with ears crashes into the left rail when sent to any left positions on rapid move. Reinstall 417 and it doesn’t. Bug in the new software settings? I’m going back to 417 till it’s worked out. Any insight to this issue or am I the only one it has happen to? Thanks.
Scott, this has been reported in probably 5 or 6 threads so far, Support and development know about this and we requested that a warning be put on the CM load page to warn users but this has not been done yet.
It works fine if you do not use the left rapid positions and you ensure that your workpiece is within the limits.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.