CNC Switch Panel

How To
1

I’m looking to create a switch panel that will be able to control the router, CNC, vacuum and an emergency shutoff. I have created this setup using separate outlets and light switches already. I want to make it again but have it have a smaller footprint.

I want to use 12v switches. However, when it comes to electrical, I’m not familiar with using devices with small requirements than 120 volts.

Curious if anyone has done this and or has any input.

2

For the vacuum there is:

https://my.carbide3d.com/faq/controlling-a-vacuum-with-your-shapeoko/

For a switch, some folks have used something like to:

https://www.rockler.com/safety-power-tool-switch

3

Control panel

1 Like
4

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.