WillAdams
November 15, 2024, 3:08pm
2
Usually our controllers only run Grbl:
We hope you'll never need this, but if you do, it's a replacement Carbide Motion PCB for Shapeoko. The Carbide Motion PCB in two options for Shapeoko 3: Stand-Alone CM Board (The heatsink and power supply are not included, this is only the PCB.) CM...
Price: USD 99.00
and Carbide Motion runs on a separate computer, though it is an option to run it on a Raspbery Pi 4 (or later):
If you’ve got a Raspberry Pi 4 lying around give this a shot over the weekend:
https://carbide3d.com/carbidemotion/pi
This was a quick R&D project and we just got it working a few hours ago so we haven’t tested it too much yet. We don’t know if the Raspberry Pi will become a supported platform for us yet, but let us know if you find it useful.
PS- Be sure you run sudo apt-get update before trying to install this package if you’re on a fresh Pi install
though usually, Carbide Motion and Carbide Create Pro are run on a separate computer:
https://carbide3d.com/hub/faq/pc-based-control/
Note that all of this is in the context of controlling Carbide 3D machines, which is all that we support, save for Carbide Create Pro making G-code which may be used on 3rd party machines.