Controller/VFD Controller Mounting

[WillAdams (William Adams (Carbide 3D))]

I did a template at:

Mounting the electronics for an SO5 Pro

Needed to mount my SO5 Pro control box out-of-the-way — while the dimensions were given in: the hole locations were not. Here’s a template I worked up — YMMV, please check against your box, &c. so5_electronics_template.pdf (1.1 KB) which worked for me: [image] [image] [image] [image] and the MDF was screwed to one side of the base of my workbench.

Please print at 100% and check against your controller.

Really though, in retrospect I should have just used a piece of paper from some packaging and shaded w/ a pencil.

There was a 3D print for this at:

Introducing the Carbide 3D Print Library

I’m brand new here but I designed and printed a controller box mounting bracket for the Shapeoko 5 Pro. Much easier than the keyhole mounts on it, especially if mounting to the underside of a table. Controller Bracket v2.stl (39.3 KB) Printed with Creality Ender 3 V2 with PLA-F, 100% infill. Two brackets do the job, I chose three screws per bracket. [IMG_6113] [Screen Shot 2023-09-14 at 11.41.56 AM]

which you might want to look into.

No VFD here, so someone else will have to chime in on that.