I created a c2d file in carbide create 764, and when i go to open it with carbide motion 622, i get the error below. i hope i didn’t royally mess up and play with a version of create that can’t load in motion! @WillAdams i did this while trying to see if i could overcome the boolean join issue in my other thread. am i out of luck at this point? thx.
Only C2D files from Carbide Create V7 are supported
Where is the file stored? Using what permissions? Filename?
Let us know the specifics and send the file to support@carbide3d.com
i opened the file in carbide create 761 and saved it, and then carbide motion 622 could open it. so it looks to be specific to 764.
Are you on Mac OS or Windows?
Where was the file saved (from 764)?
What was it named?
Where was it stored? using what permissions?
The test cuts I have done from CC764/CM622 were fine using both .c2d and .nc files.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.