I’ve been happily using Carbide Create with our Shapeoko Xl for over a year now and it’s great. The one major issue I have is the default speed for Aluminum being way too fast. There’s no way it is correct, you can’t hold down a part when it’s going that fast… But, what is the actual correct spee…

Default speeds with Aluminum

Griff (Well crap, my hypometric precursor device is blown…) September 13, 2019, 8:38pm 2

Take a minute, check around the forum, you may find a few posts re aluminum feeds and speeds.

I’ll check back when I have more time, point you to a few posts if still needed.

1 Like