Design position

#1

Using Carbide Create 474 (I have 32 bit Windows 10)

Why does a file open with the design shrunk and positioned on the left center of the screen. I can resize and position it in the center and save but it reopens as shown in the screen shot? The original was imported from a DXF, then converted to SVG and imported into Carbide Create where it was modified to the current design.

image
image1920×1080 99.5 KB

Thanks, Bill

#2

This is caused by some small object being off outside of the drawing edge.

#3

if you look carefully along the right hand side of the image just over about of a 1/3 of the way up you can see a little red object. Try select that and move it within the model area or delete it if it is not needed.
Thought it was a mark on my screen for a minute.

3 Likes