Hi!
New user of Carbide Create Pro here.
I’ve created my first “masterpiece” but when I export it to gcode to print on my proverxl 6060, all the measurements are doubled… So my 14”x8” piece ends up being 28x16.
Somebody on Facebook told me to check which post processor I’m using, but I’m not sure where this setting is. It’s my first day using creator so please be gentle 
It’s more likely that the Prover has the wrong steps/mm, or there’s a DIP switch which is wrong.
Put a plastic ruler on the bed and try measuring the jogging — is it dimensionally accurate?
Do you have a sample G-code file from the vendor which cuts to the correct size? If so, make an equivalent in Carbide Create and compare.
Found the problem. $21, 22 and 23 were double the default value for some reason that I ignore…
I reset them and now everything is ok.
This topic was automatically closed after 30 days. New replies are no longer allowed.