@MadHatter thanks for the details. As usual I over-complicated things, lopping of the router plug is just too simple and easy. I do like the idea of the EMI filter power socket, both parts are on their way. Not sure how I ever did anything before Amazon.
I finished up the wiring as far as I could go. Mickey-moused the router and controller power for now. Had to lengthen the limit switch wiring a bit and then wrapped most everything in split loom.
Really works beautifully with the new control board. Fingers crossed that the EMI issue is resolved, I wracked it around a bit turning the router on and off while doing rapids with no issues. I can even turn off the controller power and restart and CM recognizes it, that was never possible before.
Now back to F360 to finish up the table leg design CAM for a live edge table in progress:
Legs will be 8/4 walnut as is the top. Snowball effect of bricking the old control board has created a month-long interruption. It’ll be good to make some sawdust again.
Thanks again.
RMW