Extract GCode from Carbide Create

Hi there, I’ve looked this over and there is the extractor below, but it doesn’t seem to be working. I’m trying to do some mother’s day gifts. Can someone point me in the right direction?

https://my.carbide3d.com/extractgcode/

It’s working for me. You might have to refresh the page, just in case your authorization expired.

1 Like

hmmm. It keeps telling me the page is not responding. Ok, thank you Rob! At least I know it’s on my end. I’ll keep trying.

changed browser to Chrome and it worked just fine. In Edge, the upload was nearly instantaneous and then nothing. In Chrome, the upload took about 10 seconds and then worked as usual.

This topic was automatically closed after 30 days. New replies are no longer allowed.