Just wanted to say that I’ve been playing around with inlays in CC and have been loving it. If I could make one request, it would be to be able to choose a starting depth for the inlay plugs. I know the feature exists for the inlay, but not for the inlay plug as far as I know. The reason I ask is because I use quite a bit of rough cut lumber and after running it through my cheap band saw the width can be pretty variable. When doing inlays, I’ve gotten in the habit of running a surfacing pass to get a consistent depth on the inlay, then running the advanced vcarve starting from the known depth. I’d love to be able to do the same for the plug, but I don’t think there’s any way to do that as far as I know?
This topic was automatically closed after 30 days. New replies are no longer allowed.