Flatten total slat area

CNC Machines Shapeoko HDM
1

I’ve had my HDM for quite a while now…and I have been using a custom waste board. Now, I want to switch the the slats…but I just cannot figure out how to flatten the TOTAL machinable area on the HDM. Does anyone have a file or anything for quick and easy flattening?

I know that I can’t reach every area of the waste board…the gantry just doesn’t physically go that far…but I would like to have all of the slats nice and flat…and not just a 21" x 27" flat pocket in the middle of these slats.

2

Remove and rotate the slats so that you can face off the areas you can’t reach level with the top of the Hybrid T-tracks?

That’s what I did w/ the slats on my SO5 Pro after implementing the forward gantry shift.

3

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.