My 5.1 Pro arrives next week and I am looking to clear some space.
Location : South East GA.
Shipping is not really feasible.
The base machine is a Pro XXL that I bought used about 3 years ago. I replaced the control board last week because I had a crash that toasted the board.
Other stuff I am including:
110v ER-11 65mm water cooled spindle/VFD from PwnCNC purchased in September of 2024.
Pond pump and bucket for coolant, I don’t use the chiller.
IOT power strip from PwnCNC which can trigger the vac when the spindle ramps up.
Brand new Sweepy, extra sweepy insert and deep sweepy
Bitsetter
BitZero V2
10” touch screen Raspberry PI with CM loaded and an arm attached to the table.
Table to hold the whole thing which has a large drawer with foam insert for bits and tools.
1/8, 1/4 and 8mm ER-11 collets and 2 nuts and wrenches for them.
I may even throw in a couple of spare C3D routers.
Table to hold it all with a deep drawer and foam insert cut do bits and tools.
There may be some other odds and ends as well.
I am not including the bits, clamps or vac.
Looking for 3k range.
I can send specifics on any of the pieces to anyone interested.
I will drive within a couple of hours to help set it up and provide a little training. That would cover a range from Jacksonville to Charleston.