Fusion 360 Not letting me combine tool paths with same tool

[LiamN (Liam Newcombe)]

Since asking here a little while ago;

Fusion 360 CAM workflow preferences question

I’m using Fusion 360 for CAM and Carbide Motion to drive the Shapeoko (haven’t jumped into UGS yet) and wondered what people’s preferences were for exporting their CAM from Fusion for the Shapeoko. I don’t have the bitsetter (out of stock) so at the moment (I think) I need to run separate .nc files for each tool to let me use the regular bitzero X, Y, Z block to reset for Z height each time I change tool. (Have I got this wrong?) If that’s correct, then… Given that it seems to make sense (espe…

I’ve taken to making a folder under the setup for each tool and then exporting a folder at a time for jobs running the same tool;