see attachment…what does that mean? How to correct?
How was the G-code created? Using what post-processor?
Upload the .nc file here? (might need to zip it)
i was just starting up this morning. went to initialize and got the message, Ran for a couple of hours yesterday and no problem. came in this am to start up and got the message.
have never messed with G code so need some direction.,
shut everything down and restarted…both machine and carbide motion…still go the error
should i start over with set up new machine?
that didn’t work neither
Contact support — I suspect the firmware on your machine is corrupt.
This topic was automatically closed after 30 days. New replies are no longer allowed.