Hey so I have been using G-Wizard Calculator quite a bit now and it is very helpful for setting safe depth of cut but I would say the plunge rates it suggests are very scary - like I just would not use them (where I set absolute max 30mm/min it suggests 889mm/min). Also for those that come after and read this thread it is essential to set up the adjusted spindle power curve to ‘Weight Adjusted HP’.
As for the G-Wizard Editor, that this post was originally about, I had to set up a copy of the original Nomad specs (that are automatically included for the Nomad with both packages) by saving as with a different name (like ‘Nomad 883a’) and then it showed the milling rather than turning wizards as it should. After all that effort though I tried to create g code for facing but it did some weird thing where it kept trying to select the tool when I ran it on the nomad - looked okay on cutviewer though.