GCode change for start of a job

I’m wanting to change how the machine starts a job.

After it does the tool measure, I want to change the gcode to move to the start position and then drop… not drop and then move to the start position… Any guidance is appreciated.

What design program are you using? Carbide Create already does a move then a plunge.

1 Like

VCarve Pro on a Shapeoko Pro…

We have a bit on post-processors for that at:

If that doesn’t address things, please check in w/ Vectric tech support.

This topic was automatically closed after 30 days. New replies are no longer allowed.