Another McEtcher project and a 3D carve. Both using CC and CM.
nemesis_emblem.nc (311.2 KB)
3D_horse_bowl.nc.zip (1.8 MB)
2 Likes
Dmap2Gcode Roughing, Finishing Settings and included the header and postscript.
Haven’t actually run this yet.
Tiger.zip (1.4 MB)
I hope this helps.
Oops Finish settings below.
1 Like
Rotary Axis Job XAZ , Vectric VCarve Pro + Neil Ferrie’s Post-Processor. Barley Twist finishing cut.
One More 284x72 Single Beech Rev-1 8thBN.gcode.zip (278.9 KB)
One More 284x72 Single Beech Rev-1 4thBN.gcode.zip (137.3 KB)
One More 284x72 Single Beech Rev-1 4thEM.gcode.zip (484.1 KB)
Visualisation would be a big plus for me.
Rotary axis display (and ideally controls - set zero, move + move - goto axis 0) another big plus (using Vectrics I opt for XAZ, but it can also do AYZ where A is the rotary axis, but all 5 axes remain fully functional on the machine XYYZA in my case, SO3XL/HDM).
An ‘expert’ option for a single (or very few) screen(s) that shows/controls everything rather than being baby-sat through every step every time.
Always (or almost always) active and accessible keyboard shortcuts to better support jog dial users.
Noting/displaying the gcode line last processed in the event of the system becoming unresponsive, or the user cancelling the JOB - would give a major boost to tracking down the line and from that finding a suitable prior resumption line.
Any improvement on estimated run time would be welcomed
2 Likes
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.