Gifted a HY02D223B VFD and spindle - need resources

[Julien]

Hi @Funkythunder,

for setting up the VFD there is always my old thread:

VFD Parameters (Huanyang model)

and while I’m here, two wiring snapshots . 220V Hot and Neutral wired to R and T (apparently, it would also work with R and S or S and T too), Earth connected to the VFD’s earth terminal Spindle’s aviation connecteur pin 1 to U, pin 2 to V, pin 3 to W, pin 4 to Earth terminal [VFD_wiring_mains] For control signals, I followed @Luke’s instructions religiously: FOR(ward) to DCM(ground) = forces forward rotation, i.e. the right direction. Shapeoko’s GND to ACM (ground) Shapeoko’s PWM to VI (v…

(and dozens of others, but admittedly the info is sometimes scattered here and there)

and then you need to pick up the PWM signal from the Shapeoko controller, I’m not familiar with the latest generation (warthog) but I’m sure the info is on the forum somewhere.

EDIT: maybe this

Spindle/router connector pinout

The original Carbide Control boards and the Warthog controller out 5v for the on and off of a trim router and 0-5v for a VFD/Spindle. [Screenshot_20240416_212000_Messenger]