Hi! It’s Walter here from Italy… I own a Shapeoko 3, one of those early batches… And I have just updated to grbl 1.1, yes, better than never :wink: But I experience a problem, the machine count double, 10mm became 20mm and so on. I’ve used the Carbide motion settings to generate the config file……

[shapeoko3_board] And it works as expected! I confirm, need to to toggle switches to 8x. TKS to all for your help!!

Grbl 1.1 editing? NO, it's just the board... SOLVED

Julien (Julien) August 4, 2021, 6:24pm 4

Just for confirmation, here’s one of the post where Will confirmed the DIP switches need to be toggled to 8x

3 Likes