My Shapeoko 3XXLhas quit homing and won’t reach the correct front position to hit the center of the bitzero button on the front right corner.
Are the belts in good condition and correctly tensioned?
Is anything mechanically interfering w/ the movement?
Pulley set screws on all motors secure and in place?
If you in the US we have been in a deep freezer for a few days. People are reporting all kinds of issues likely because of the cold. I am not saying try to not trouble shoot but if you can wait until more temperate weather the problems may just go away.
You can resend your configuration and set the BitSetter location again. Otherwise just wait until the thaw comes and it will.
This topic was automatically closed after 30 days. New replies are no longer allowed.