How to add a spoilboard bit to library

[WillAdams (William Adams (Carbide 3D))]

Extensive discussion at:

Origin/consistency of chipload recommendations

I’ve been going back to the basics of the whole feeds and speeds thing for a minute, and this time I want to focus on chipload values only, not the infinite number of associated RPM/feed combinations. I collected a small sample of feeds and speeds below from: usual recommand values from 3 or 4 different web sites what CarbideCreate uses the Shapeoko feeds and speeds chart for the #201, 1/4" endmills Will’s [Tableau] (https://public.tableau.com/profile/willadams#!/vizhome/Carbide3DCNCFeedsand…

and

Feeds & speeds