How to use the shapeoko touch probe on ugs platform?

[RichCournoyer (Richard Cournoyer)]

This should help even more:

UGS touchplate macro

Since I recently updated my grbl to 1.1f I was able to take advantage of G38.2 I use this as a macro in UGS G38.2 z -.5 F1; G92 Z .065; G0 z .25 G38.2 Z -.5 F1 probes down .5 inch at 1 inch/min G92 Z.065 sets Z to touch plate thickness (I use a copper clad pcb .065 thick) G0 Z .25 retract tool Position the tool at .5 inch or lower above touch plate (or change the Z higher if you like, keep in mind that it probes down at 1 inch/minute) Run the macro. The tool will descend at 1 ipm unt…

Wow…Google!