RuiMartins
(Rui Martins)
November 18, 2023, 11:30am
1
Hello.
I cant change the dimensional limits of my Sp XXL PRO in new CM? I was running in the old program and everything was fine now i nstallthe update and i can`t change de dimensional limits from 850 to 855 to correct the bitsetter position.
Thank you in advance
WillAdams
(William Adams (Carbide 3D))
November 18, 2023, 12:53pm
2
First, try re-tensioning the Y-axis belts (and X) probably not taut enough.
It might be that you have enough adjustment in your Y-axis homing switch location to get it positioned as necessary. If not,
Configure the machine w/o the BitSetter, then initialize it, then calibrate for belt stretch:
The typical technique for machine calibration:
https://my.carbide3d.com/faq/belt-stretch/
depends on precision measuring tools, and is limited by the reach of the tools in question.
EDIT:
It also depends on access to the MDI — if using Carbide Motion v6 it will be necessary to enable this in Settings | Options:
[image]
It should be possible to cut strips from a suitable blank of material, one along each axis — so we set up a square file which matches an available blank of material:
[ima…
1 Like
system
(system)
Closed
December 18, 2023, 12:54pm
3
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.