I figured it out now the toolpath

Ok I figured out how to make the letters look like I needed them to. Now how do I cut it, this will be the first one of these I have cut and other then a push stick the only thing this advanced for me who’s done very very small projects so far. Any help is appreciated.

I’m not very good with the toolpaths in this program as I don’t find them user friendly.

Please see:

Note that the narrowest area of a given path must be at least 10% wider than the endmill you are using.

If you continue to have difficulties please post your file or send it in to us at support@carbide3d.com

This topic was automatically closed after 30 days. New replies are no longer allowed.