I can’t seem to find the “file” needed, and I’m also wondering if there’s one specific to the 5? thx.
Did you already set up your toolpaths?
You just need to use the “Carbide 3D mm” post processor. That’s it as far as the creation of a proper gcode file to run a Shapeoko.
3 Likes
In the list of post processors in Fusion360, it is just “Carbide 3D” no “mm” after the name.
3 Likes
That’s the one. I think I’m confusing name with the one in Vectric.
2 Likes
This topic was automatically closed after 10 days. New replies are no longer allowed.